CardLock was created with the purpose of satisfying the need
for an access control system where data analysis was not required. For this reason,
CardLock does not keep any information about the access control, it simply controls
the access.
The operation of this card reader and validator was simplified
to the maximum extent. It does not require any kind of software to configure it.
The configuration is made with a configuration card, which can be pre-programmed
with the RFID Reader/Writer.
With this card it is possible to register new cards,
change the internal and external readers, the relay activation time and the
authorized card numbers.
The authorized card numbers are stored in CardLock, which has
a storage capacity of 50 to 200 different cards.
CardLock includes a sound warning and 2 LEDs, with which it
indicates if it is operational and if the read card is valid.
Usually supplied with the RFID RD II
reader, it allows for bidirectional access control. It can be used to control the
access to restricted areas for a small number of users, validating card numbers or
series..
It is without a doubt a simple solution for an access control
equally simple.
